STMicrocontroller STM8S103F2 Secured Flash Memory Program Reading needs to unlock the locked bits over stm8s103f2 flash memory by focus ion beam and then clone extracted firmware to new microprocessor stm8s103f2 serve as original unit;
For efficient power management, the application can be put in one of four different low- power modes. You can configure each mode to obtain the best compromise between the lowest power consumption, the fastest start-up time and available wakeup sources.
Wait mode: In this mode, the CPU is stopped, but peripherals are kept running. The wakeup is performed by an internal or external interrupt or reset which can be used for readout microprocessor stm8s003k3 flash software.
Active halt mode with regulator on: In this mode, the CPU and peripheral clocks are stopped. An internal wakeup is generated at programmable intervals by the auto wake up unit (AWU).
The main voltage regulator is kept powered on, so current consumption is higher than in active halt mode with regulator off, but the wakeup time is faster. Wakeup is triggered by the internal AWU interrupt, external interrupt or reset.
Active halt mode with regulator off: This mode is the same as active halt with regulator on, except that the main voltage regulator is powered off, so the wake up time is slower in the process of extract stm8s003k3 flash memory heximal code.
Halt mode: In this mode the microcontroller uses the least power. The CPU and peripheral clocks are stopped, the main voltage regulator is powered off. Wakeup is triggered by external event or reset.
