STM8S103F3P6 Microprocessor Embedded Firmware Restoration is a process starts from break off mcu stm8s103f3 protective system, and then clone original locked program code from microcontroller stm8s103f3p6 flash memory;
Maximum speed: 8 Mbit/s (fMASTER/2) both for master and slave
Full duplex synchronous transfers
Simplex synchronous transfers on two lines with a possible bidirectional data line
Master or slave operation – selectable by hardware or software
CRC calculation
1 byte Tx and Rx buffer
Slave/master selection input pin
I2C
I2C master featuresClock generationStart and stop generationI2C slave featuresProgrammable I2C address detectionStop bit detection which will help to copy protective stm8s103f3 microprocessor flash heximal;
Generation and detection of 7-bit/10-bit addressing and general callSupports different communication speedsStandard speed (up to 100 kHz) fast speed.
As shown in the rightmost column of the pin description table, some alternate functions can be remapped at different I/O ports by programming one of eight AFR (alternate function remap) option bits.
Refer to Section 8: Option bytes. When the remapping option is active, the default alternate function is no longer available for the purpose of extracting stm8s103k3 microcontroller program.
To use an alternate function, the corresponding peripheral must be enabled in the peripheral registers. Alternate function remapping does not effect GPIO capabilities of the I/O ports (see the GPIO section of the family reference manual, RM0016).
