Encrypted MCU STM32F302RD Flash Content Cloning means tamper resistance system of microcontroller stm32f302rd flash memory will be unlocked, recover the encrypted flash data to new microprocessor stm32f302rd;

1. All main power (VDD, VDDA) and ground (VSS and VSSA) pins must always be connected to the external power supply, in the permitted range.
2. This current consumption must be correctly distributed over all I/Os and control pins.The total output current must not be sunk/sourced between two consecutive power supply pins to readout stm32f048g6 locked mcu flash firmware, referring to high pin count LQFP packages.
3. Positive injection is not possible on these I/Os and does not occur for input voltages lower than the specified maximum value.
4. A positive injection is induced by VIN > VDD while a negative injection is induced by VIN< VSS. IINJ(PIN) must never be exceeded to extract stm32f048g6 microcontroller heximal file. Refer to Table 16: Voltage characteristics for the maximum allowed input voltage values.
5. A positive injection is induced by VIN > VDDA while a negative injection is induced by VIN< VSS. IINJ(PIN) must never be exceeded. Refer also to Table 16: Voltage characteristics for the maximum allowed input voltage values. Negative injection disturbs the analog performance of the device. See note ⁽²⁾ below Table 81.

When several inputs are submitted to a current injection, the maximum SIINJ(PIN) is the absolute sum of the positive and negative injected currents (instantaneous values).