Clone STM8L101K3T6 Microcontroller Flash Firmware needs to decrypt stmicrocontroller stm8l101k3 locked flash memory, dump the flash content to new stm8l101k3 mcu;
The current consumption is a function of several parameters and factors such as the operating voltage, ambient temperature, I/O pin loading, device software configuration, operating frequencies, I/O pin switching rate, program location in memory and executed binary code.
The current consumption is measured as described in Figure 11: Current consumption measurement scheme.
All Run-mode current consumption measurements given in this section are performed with a reduced code that gives a consumption equivalent to CoreMark code by extracting stm8l052c6 ic mcu flash code.
The data provided apply to standard dies only.
Typical and maximum current consumption
The MCU is placed under the following conditions:
- All I/O pins are in input mode with a static value at VDD or VSS (no load)
- All peripherals are disabled except when explicitly mentioned
- The Flash memory access time is adjusted to the fHCLK frequency (0 wait state from 0 to 24 MHz and 1 wait state above 24 MHz) to copying stm8l052r8 mcu flash memory program;
- Prefetch is ON when the peripherals are enabled, otherwise it is OFF (to enable prefetch the PRFTBE bit in the FLASH_ACR register must be set before clock setting and bus prescaling)
- When the peripherals are enabled fPCLK = fHCLK
The parameters given in Table 20 to Table 26 are derived from tests performed under ambient temperature and supply voltage conditions summarized in Table 15: General operating conditions.
