Break ATMEL AVR Microprocessor ATmega8L Fuse Bit

Break ATMEL AVR Microprocessor ATmega8L Fuse Bit and retrieve atmel avr mcu atmega8l flash heximal, and copy atmel avr microcontroller atmega8l firmware data to new mcu;

reverse atmega8l avr chipset and copy its source code
reverse atmega8l avr chipset and copy its source code

High-performance, Low-power AVR 8-bit Microcontroller

· Advanced RISC Architecture

– 130 Powerful Instructions – Most Single-clock Cycle Execution

– 32 x 8 General Purpose Working Registers

– Fully Static Operation

– Up to 16 MIPS Throughput at 16 MHz

– On-chip 2-cycle Multiplier

romper ATMEL AVR microprocesador ATmega8L fusible bit y recuperar atmel avr mcu atmega8l flash heximal, y copiar atmel avr microcontrolador atmega8l datos de firmware a la nueva mcu
romper ATMEL AVR microprocesador ATmega8L fusible bit y recuperar atmel avr mcu atmega8l flash heximal, y copiar atmel avr microcontrolador atmega8l datos de firmware a la nueva mcu

High Endurance Non-volatile Memory segments

 

– 8K Bytes of In-System Self-programmable Flash program memory

– 512 Bytes EEPROM

– 1K Byte Internal SRAM

– Write/Erase Cycles: 10,000 Flash/100,000 EEPROM (1)(3)

– Data retention: 20 years at 85°C/100 years at 25°C (2)(3)

– Optional Boot Code Section with Independent Lock Bits

In-System Programming by On-chip Boot Program True Read-While-Write Operation

– Programming Lock for Software Security

Break ATMEL AVR Microprocessor ATmega8L Fuse Bit and retrieve atmel avr mcu atmega8l flash heximal, and copy atmel avr microcontroller atmega8l firmware data to new mcu
Break ATMEL AVR Microprocessor ATmega8L Fuse Bit and retrieve atmel avr mcu atmega8l flash heximal, and copy atmel avr microcontroller atmega8l firmware data to new mcu

Peripheral Features

– Two 8-bit Timer/Counters with Separate Prescaler, one Compare Mode

– One 16-bit Timer/Counter with Separate Prescaler, Compare Mode, and Capture Mode

– Real Time Counter with Separate Oscillator

– Three PWM Channels

– 8-channel ADC in TQFP and QFN/MLF package

Eight Channels 10-bit Accuracy

– 6-channel ADC in PDIP package

Six Channels 10-bit Accuracy

– Byte-oriented Two-wire Serial Interface

– Programmable Serial USART

– Master/Slave SPI Serial Interface

– Programmable Watchdog Timer with Separate On-chip Oscillator

– On-chip Analog Comparator

Special Microcontroller Features

– Power-on Reset and Programmable Brown-out Detection

– Internal Calibrated RC Oscillator

– External and Internal Interrupt Sources

– Five Sleep Modes: Idle, ADC Noise Reduction, Power-save, Power-down, and Standby I/O and Packages

– 23 Programmable I/O Lines

– 28-lead PDIP, 32-lead TQFP, and 32-pad QFN/MLF Operating Voltages

– 2.7 – 5.5V (ATmega8L)

– 4.5 – 5.5V (ATmega8) Speed Grades

– 0 – 8 MHz (ATmega8L)

– 0 – 16 MHz (ATmega8)

Power Consumption at 4 Mhz, 3V, 25°C

– Active: 3.6 mA

– Idle Mode: 1.0 mA

– Power-down Mode: 0.5 µA