Connection to a target device is typically done through an ICSP™ header by Extract Chip AT87F51RC Code. A commonly found connector on development tools is the RJ-11 in the 6P6C (6 pin, 6 connector) configuration. See below Figure:

Another connector often found in use with the PICkit™ programmers is a standard 6-pin header with 0.1 inch spacing which is useful for Extract MCU Process. Refer to below Figure.

For additional interface recommendations, refer to your specific device programmer manual prior to PCB design in order to Extract MCU AT89C51CC02 Code.

It is recommended that isolation devices be used to separate the programming pins from other circuitry through Break IC Source Code. The type of isolation is highly dependent on the specific application and may include devices such as resistors, diodes, or even jumpers before Extract IC AT87F51RB2 Eeprom. See below Figure for more information.