ST Microprocessor ST72F32AK1 Embedded Flash Firmware Copying is a process to break stmicrocontroller st72f32ak1 flash memory protection by reset its security fuse bit then make MCU st72f32ak1 cloning;
8K dual voltage High Density Flash (HDFlash) or ROM with read-out protection capability. In- Application Programming and In-Circuit Pro- gramming for HDFlash devices
384 bytes RAM
HDFlash endurance: 100 cycles, data reten- tion: 40 years at 85°C
■ Clock, Reset And Supply Management
Clock sources: crystal/ceramic resonator os- cillators and bypass for external clock
PLL for 2x frequency multiplication
Four Power Saving Modes: Halt, Active-Halt, Wait and Slow
■ Interrupt Management
Nested interrupt controller
14 interrupt vectors plus TRAP and RESET
6 external interrupt lines (on 4 vectors)
■ Up to 32 I/O Ports
32/24 multifunctional bidirectional I/O lines
22/17 alternate function lines
12/10 high sink outputs
■ 4Timers
Main Clock Controller with: Real time base, Beep and Clock-out capabilities
Configurable watchdog timer
Two 16-bit Timers with: 2 input captures, 2 output compares, PWM and pulse generator modes to readout microprocessor stm8s003k3 software content;
■ 2 Communications Interfaces
SPI synchronous serial interface
SCI asynchronous serial interface
– 10-bit ADC with up to 12 robust input ports
■ Instruction Set
8-bit Data Manipulation
63 Basic Instructions
17 main Addressing Modes
8 x 8 Unsigned Multiply Instruction
■ Development Tools
Full hardware/software development package
In-Circuit Testing capability
