Readout DSP Microcontroller TMS320F28034 Flash Data needs to disable the fuse bit of MCU tms320f28034 through unlocking dsp controller, the location of fuse bit will be found by reverse engineering processor tms320f28034;

The 280x devices are full static CMOS devices. Three low-power modes are provided:

IDLE:          

Place CPU into low-power mode. Peripheral clocks may be turned off selectively and only those peripherals that need to function during IDLE are left operating. An enabled interrupt from an active peripheral or the watchdog timer will wake the processor from IDLE mode in order to carry out the task.

STANDBY:

Turns off clock to CPU and peripherals. This mode leaves the oscillator and PLL functional. An external interrupt event will wake the processor and the peripherals when readout tms320f28026 dsp mcu memory program. Execution begins on the next valid cycle after detection of the interrupt event.

HALT:         

Turns off the internal oscillator. This mode basically shuts down the device and places it in the lowest possible power consumption mode. A reset or external signal can wake the device from this mode.