We can Extract Microchip MCU PIC16F917 Code, please view the Microchip MCU PIC16F917 features for your reference:
High-Performance RISC CPU:
Only 35 instructions to learn:
– All single-cycle instructions except branches
Operating speed:
– DC – 20 MHz oscillator/clock input
– DC – 200 ns instruction cycle
Program Memory Read (PMR) capability
Interrupt capability
8-level deep hardware stack
Timer2: 8-bit timer/counter with 8-bit period
Timer0: 8-bit timer/counter with 8-bit
Power-saving Sleep mode
Wide operating voltage range (2.0V-5.5V)
Industrial and Extended temperature range
Power-on Reset (POR)
Power-up Timer (PWRT) and Oscillator Start-upEnhanced Low-Current Watchdog Timer (WDT).
In-Circuit Serial Programming™ (ICSP™) via twoDirect, Indirect and Relative Addressing modes
Special Microcontroller Features:
Precision Internal Oscillator:
– Factory calibrated to ±1%
– Software selectable frequency range of 8 MHz to 32 kHz
– Software tunable
– Two-Speed Start-up mode
– Crystal fail detect for critical applications
– Clock mode switching during operation for power savings Timer (OST)
Brown-out Reset (BOR) with software control
option with on-chip oscillator (software selectable nominal 268 seconds with full prescaler) with software enable
Multiplexed Master Clear with pull-up/input pin
Programmable pic16f917 code protection
High-Endurance Flash/EEPROM cell:
– 100,000 write Flash endurance
– 1,000,000 write EEPROM endurance
– Flash/Data EEPROM retention: > 40 years
Low-Power Features:
Standby Current:
– <100 nA @ 2.0V, typical
Operating Current:
– 8.5 ìA @ 32 kHz, 2.0V, typical
– 100 ìA @ 1 MHz, 2.0V,
Watchdog Timer Current:
– 1 ìA @ 2.0V, typical
Peripheral Features:
Liquid Crystal Display module:
– Up to 60 pixel drive capability on 28-pin devices
– Up to 96 pixel drive capability on 40-pin devices
– Four commons
Up to 35 I/O pins and 1 input-only pin:
– High-current source/sink for direct LED drive
– Interrupt-on-pin change
– Individually programmable weak pull-ups pins
Analog comparator module with:
– Two analog comparators
– Programmable on-chip voltage reference (CVREF) module (% of VDD)
– Comparator inputs and outputs externally accessible of PIC16F917
A/D Converter:
– 10-bit resolution and up to 8 channels programmable prescaler
Enhanced Timer1:
– 16-bit timer/counter with prescaler
– External Gate Input mode
– Option to use OSC1 and OSC2 as Timer1 oscillator if INTOSCIO or LP mode is selected register, prescaler and postscaler
Addressable Universal Synchronous
Asynchronous Receiver Transmitter (AUSART)
Up to 2 Capture, Compare, PWM modules:
– 16-bit Capture, max. resolution 12.5 ns
– 16-bit Compare, max. resolution 200 ns
– 10-bit PWM, max. frequency 20 kHz
Synchronous Serial Port (SSP) with I2C™
